KD35 is a 3.5" cinewhoop for a more powerful and stronger build than the 3". This frame has the props closer together and overlapping the electronics, which creates a smaller footprint, while still allowing clean exit airflow. It's a compact, stiff frame with fantastic performance and lower moment of inertia compared to traditional designs. It also features a mounted XT60 and the ability to mount an action camera on the front AND the rear.
Specs:
Weight: 155g
Size: 199 x 204 x 40 mm
Mounting: 30.5 x 30.5 and 20 x 20 ESC/FC stack, 20 x 20 and 25.5 x 25.5 VTX, 12 x 12 M2 and 16 x 16 M3 Motor pattern
Frame kit includes:
- T700 Carbon: 1x top plate, 1x bottom plate, 8x motor spacers
- Hardware
- Motor screws
- FC/ESC screws and nuts
- 3D Prints
- Mounted XT60
- Battery strap
- STLs and a Betaflight 4.4 tune can be downloaded for free from the KD35 GrabCAD page. The tune is used at your own risk and will not be suitable for all builds.
Recommended Parts (not included):
- 2207 2400kv motors
- HQ D90 3 blade or 5 blade
- Any 20 x 20 or 30 x 30 40A+ ESC and FC
- 6s 1300-1500 mAh Lipo
- Any VTX, almost all should fit
- Custom PIDtoolbox tune, available here: https://ptblabs.ca/
top of page
Rating is 5.0 out of five stars based on 1 review
£129.95Price
Excluding VAT
Out of Stock
bottom of page
Reviews
This is a very versatile little whoop. Which at 3.5", the footprint is kept to a minimum while the possibilities are virtually endless.
For example a lightweight setup using a naked Gopro + 850mah 6S, or a full-size Gopro + 1400mah 6S, or 2 naked gopro's, or a bottom/top mounted O4 gimbal, or even a gimballed Gopro (if you figure out how to control it). In the included picture the craft is 'in between experiments', I'm having a lot of fun with it without braking the bank.